Oberon 1010-00 Manuel d'utilisateur télécharger pdf

Installation Instructions

Model Number 1010-00

(877) 867-2312 • www.oberonwireless.com

P/N 2181 – Rev. 07/30/2014 Oberon, Inc.

•

1315 South Allen Street

•

Figure 3

Assembly Components:

- Right angle wall mount – 1 each

- 1” Flexible rubber grommet – 1 each

- #8 - 32 screw (for attaching access point mounting plate) – 4 each

- Installation Instructions – 1 each

If any of these items are missing, contact your Oberon representative.

Find a flat work surface to assemble the mount, access point’s mounting plate, conduit clamp(s), T-bar clip, and antenna(s)

prior to mounting on wall.

Step 1 – Place the mount assembly on the work surface.

Step 3 – If applicable, install the conduit clamp(s). Clamps can be installed on either side of the mount or the cover by

removing the ½” trade size knockout punch.

The mount is now ready for wall mounting.

Page 2

Step 4 – Place the mount on the wall where it is to

be installed (it is recommended that you mount

directly to a stud if possible) and mark the screw

locations. Use a minimum of two (2) #10 x 2” or

larger screws (not included) to secure the mount

in place. However, if there is no stud at the

mounting location, it is recommended that you use

a minimum of 4 suitable anchors to secure the

mount in place (Figure 3).

Step 5 – Run the data and power cable (if

required) through the conduit clamp located on

sides of the mount. The mount has a cutout in it

that can accommodate a wall plate for data

termination. Run data and power cable (if

required) through the flexible rubber grommet.

Step 6 – Attach the data and power cables to the

access point prior to securing the access point to

the mounting bracket. After the access point is

secured to the mounting bracket, attach antennas

to the access point if required.

**IMPORTANT** - It is important that the

mount is securely fastened to the wall to

prevent human injury or damage to the access

point.

Page 3

Figure 2

Figure 1

Step 2a (Cisco Access Points Only) – Use the

legend on the back page to determine which hole

pattern to use (Figure 4). Securely fasten the

access point’s mounting bracket to the mount

using the included (4) # 8-32 screws (Figure 1).

Step 2b (Other Manufacturers) – Fasten the

provided T-Bar bracket in the best position for the

access point, then securely fasten the access

point and its respective mounting plate or bracket

(Figure 2).

1 2

Installation Instructions 1

Résumé du contenu

Page 1 - Installation Instructions

Installation Instructions Model Number 1010-00 (877) 867-2312 • www.oberonwireless.com P/N 2181 – Rev. 07/30/2014 Oberon, Inc. • 1315 South All

Page 2

Figure 4 Page 4 MODEL 1010-00 Installation Instructions **** WARNING **** Please thoroughly read

Commentaires sur ces manuels

Pas de commentaire

Oberon 1010-00 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires de communication Oberon 1010-00. Oberon 1010-00 User Manual [it] [de] [fr] [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Oberon 1010-00